877-764-3337 • 406-388-2377 • Mon-Fri 9am-5pm MST Login
Dobeck Performance   Dobeck YouTube   Dobeck Twitter   Dobeck Facebook   Made in the USA
Powerlab EFI programming


Power Sports and Electronic Fuel Injection Glossary

PETCOCK

The fuel valve, usually found on the side of the gas tank.

PINGING

Metallic noise produced by a faulty combustion cycle inside the cylinder also known as knocking.

PLANAR LAMBDA OXYGEN SENSOR

In its basic operating concept the planar sensor corresponds to the heated finger-type element sensor by generating a response curve with a characteristic jump at lambda=1. At the design level the planar sensor is distinguished from the finger-type unit.

PLUGS

One example of the available connection techniques is the plug connection at the high-voltage terminal towers of the ignition distributor. Socket version A has only a relatively low high-voltage strength and is thus encountered only in isolated cases in original equipment applications.

POLLUTANT EMISSION

The ignition angle Az or the ignition point has an important influence on the exhaust-gas values, the torque the fuel consumption and the drivability of the spark-ignition engine. The most important pollutants in the exhaust gas are the unburned hydrocarbons (HC), oxides of nitrogen (NOx) and carbon monoxide (CO).

POLARIS

A brand of motorcycle, atv, and snowmobile produced in the United States.

POST-START ENRICHMENT

Enrichment with additional fuel improves the post-start performance at low temperatures. This function is calibrated to give satisfactory throttle response at all temperatures together with minimum fuel consumption.

POST-START PHASE

Following low-temperature starts, supplementary fuel is required for a brief period, until the combustion chamber heats up and improves the internal mixture formation. This richer mixture also increase torque to furnish a smoother transition to the desired idle speed.

POWER COMMANDER

Fuel injection product from Dynojet.

PRESSURE CHARGING

Because maximum possible torque is proportional to fresh-air charge density, it is possible to raise power output by compressing the air before it enters the cylinder.

PSI

Pounds per square inch (PSI) is the common unit of measurement for pressure. Normal atmospheric pressure at sea level is 14.7 psi.


DEVELOPMENT CENTERS RESOURCES ACCOUNT ABOUT DOBECK
GEN 3 Manuals User Account Contact
GEN 3.5 Coder Software Facebook
GEN 4 FAQ Twitter
YouTube

 A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z 
Thank you for visiting PowerlabHQ.com where we provide power sport enthusiasts tuning electronics.

© 2005-2024 Dobeck Performance. Manufacturer of tuning products. All Rights Reserved. Privacy Policy